Hack a HK UBEC to change the output voltage
UBECs are voltage regulators and most have a fixed output voltage of between 5V and 6V. This video shows you how to hack one of HobbyKing's UBECs to output a higher voltage -- such as 12V for powering an FPV camera/transmitter from a 4S lipo or for powering a couple of high-intensity LEDs like I have for my quadcopter.
Here are the resistor values used to obtain new voltages (within 0.4V or so):
56K Ohm = 6V output
33K ohm = 7V output
10K ohm = 10V output
8.2K ohms = 11V output
6.8K ohms = 12V output
Note: in order to get these output voltages, the input voltage must obviously be higher. For example, you can't get 12V out if you're only putting 7.4V in :-)
Here are the resistor values used to obtain new voltages (within 0.4V or so):
56K Ohm = 6V output
33K ohm = 7V output
10K ohm = 10V output
8.2K ohms = 11V output
6.8K ohms = 12V output
Note: in order to get these output voltages, the input voltage must obviously be higher. For example, you can't get 12V out if you're only putting 7.4V in :-)
Mdp.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.