(2/6) CC3D Flight Controller - Radio setup, firmware install and testing

Consider supporting the channel by visiting www.patreon.com/painless360
To see all of the videos in this series visit ...
You can see the frame kit used in this video by visiting
This video has been created for first time builders so they can understand where each piece of a build fits and follow each of the steps easily. Some more experienced builders my find that going straight to the second video in the series, where I setup the board, may be of more interest.
In this video I introduce the excellent CC3D and cover the second half of the elements needed to make your first quad copter.
- Introduction (0:02)
- Explanation of BEC (what is does - switched and linear) (1:34)
- Plugging in the ESC connectors (2:40)
- Motor installation tip (4:14)
- Plugging in the receiver connections (5:30)
- Useful websites (8:57)
- Installing GCS on the PC (9:41)
- Installing the firmware to the board (10:55)
- Installing firmware (13:09)
- Calibrating gyros and accelerometers (15:27)
- Calibrating the ESCs (15:43)
- Setting up the ESCs and checking motor direction (18:08)
- Setting up the transmitter (20:04)
- Setting up the arming process (23:02)
- Choosing the flight modes (23:40)
- Checking orientation (24:33)
- Installing the props (25:25)
- Checking the weight of the model (26:25)
- Test hover!!! (27:08)
After checking the ESCs work fine on the faster update setting. You can read the manual for the ESCs here - ...
Thanks for watching, please LIKE and SUBSCRIBE.
Happy flying!