KingKong 95GT 95mm Micro FPV Racing Drone
KingKong 95GT is a 95mm brushless mini FPV racing drone with an F3 board, 4n1 10AMP Blheli_S DSHOT ESCs, 25mw 16ch VTX, 800tvl camera weighing in at just 50g. The motors are 1103 7800KV motors with 1935 tri-blade propellers. The lightweight canopy (white + yellow included) protects the flight controller, camera, and vtx and gives the drone a sleek look.
This little quad is crazy fast when you give it throttle. It's perfect for learning acro, but can also be flown just fine in stabilized modes. The low profile means that you can fly it almost anywhere - including small backyards.
Unfortunately it does not ship with a later version of Betaflight, and even though you can still fly it out of the box without any issues, you'll have to flash the newest version if you want to take advantage of DShot 600.
─── BetaFlight Flash Howto ───
To flash this model to the newest BetaFlight:
1. Hold down the bootloader button and plug in the included USB cable, keep holding
2. Set the baud rate to 256000, and then fi that doesn't work, 115200
3. Set no reboot sequence, flash on connect, full chip erase.
4. Load the 3.1.x or higher firmware (3.1.6 recommended) and flash it...
You may get "verification failed", if so, no worries as long as you can connect to it afterward.
─── Where to Buy? (GearBest) ───
This little quad is crazy fast when you give it throttle. It's perfect for learning acro, but can also be flown just fine in stabilized modes. The low profile means that you can fly it almost anywhere - including small backyards.
Unfortunately it does not ship with a later version of Betaflight, and even though you can still fly it out of the box without any issues, you'll have to flash the newest version if you want to take advantage of DShot 600.
─── BetaFlight Flash Howto ───
To flash this model to the newest BetaFlight:
1. Hold down the bootloader button and plug in the included USB cable, keep holding
2. Set the baud rate to 256000, and then fi that doesn't work, 115200
3. Set no reboot sequence, flash on connect, full chip erase.
4. Load the 3.1.x or higher firmware (3.1.6 recommended) and flash it...
You may get "verification failed", if so, no worries as long as you can connect to it afterward.
─── Where to Buy? (GearBest) ───
Mdp.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.