QAV180 Speed Build

Build video of the QAV180 frame. I filmed almost the entire build and sped up the video where not much interesting is going on. At the end of various steps the video is slowed down to show work completed.
Note the captions at each section of the video for reference.
I decided to use a Flip32 board (no pins) instead of a Naze32 board this time around. I directly soldered all wires directly to the Flip32 without any connector pins. This lets me shove all motor signal wires, ESC wires and other power wires in between the Flip32 and the PDB.
Also the Flip32 was installed upside down and rotated counter clockwise 90 degrees to allow the USB port to come out the back and also keep the chips from being exposed.
This is a fairly easy build and only took me about 4 hours.
If there are any questions about anything that might be unclear, please feel free to leave a comment below. I will try and clarify as best I can.
Parts List:
QAV180 Frame -
DYS 20a OPTO ESC -
EMAX RS2205 motors -
Flip32 FC -
FrSky D4R-ii Receiver -
TS5823 200mW vTX -
MY GEAR:
RunCam2 -
Xiaomi Yi Action Camera -
FrSky Taranis X9D Plus -
Fatshark Dominator V3 Goggles -
What I use to edit my videos -
What I use to film my videos -
SUBSCRIBE TO MY CHANNEL -
"Relaxing Piano Music" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
/