Betaflight 3.4 & 3.5 Setup For Total Beginners

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST:
SUPPORT ME ON PATREON at:
THIS IS MY FULL TIME JOB. Here are other ways that you can support me: /
---
0:00 - Introduction
01:47 - Download and install Betaflight Configurator
Download Betaflight configurator at:
03:04 - Download and install drivers
Download CP210 drivers at:
PREFERRED: Download STM32 VCP drivers from my web site at:
ALTERNATE: Download STM32 VCP drivers from the official site at:
08:00 - Backup your Flight Controller configuration
09:03 - Flash the FC to the latest version of Betaflight
09:56 - Bootloader mode and ImpulseRC Driver Fixer
Download the ImpulseRC Driver Fixer at:
13:23 - Bind your receiver
How to bind Spektrum Satellite receiver, Method 1:
How to bind Spektrum Satellite receiver, Method 2:
How to bind FrSky RXSR (and others):
How to bind FlySky FS-X6B
14:31 - Receiver Setup
Flight Controller Wiring For Beginners playlist:
18:52 - Channel Mapping
20:12 - Set up Arming Switch
Full written instructions for setting up an arming switch on OpenTX, Spektrum, and FlySky are in the manual of the Holybro Kopis 1 at:
24:52 - Other Flight Modes
My full tutorial video about setting up Flight Modes is:
My video about calibrating and trimming acceleromter for autolevel mode is:
My video about acro trainer is:
26:16 - Making The Motors Spin
29:42 - Test Arming and Failsafe
31:32 - Ready to Fly?
32:45 - Adjust Channel Endpoints, Center, Deadband
Full instructions for adjusting channel endpoints and center are in my manual for the Holybro Kopis 1 at:
35:33 - Final steps to improve performance
My video about Betaflight Rates is:
42:00 - Conclusion
My Betaflight 3.4 "new feature preview" video is:
My flight test of Betaflight 3.4 is:
==