Flat Wing Nano Talon Update

Here's a quick update on the Nano Talon "flat wing conversion". In short, I wrecked it, broke it, made it better, and flew it some more... lol
I broke the fuselage when I cartwheeled it on a bad launch, but all the printed parts survived so that's a plus. I changed the center piece a little to make it better, which I explain in the video. It should be an easy swap if you already printed the other parts. More flight footage at the end!
All the parts can be found here on Thingiverse: I've also put them on Shapeways for those without access to a printer:
Relevant affiliate links:
Nano Talon PNP -
Nano Talon Kit -
Nano Talon PNP w/FPV -
I print my parts on the Anet A8 -
Here's a playlist of previous Nano Talon videos:
__
Patreon:
You can help to support my channel by using the affiliate links below when making a purchase:
Banggood -
eBay -
Amazon -
Foxeer -
You can also make a donation if you wish to do so at the following link:
Support my channel and my efforts to bring you better content, every little bit helps!
Here's some affiliate links to the video gear I use from Ready Made R/C:
1.3GHz video transmitters (I use 200, 400, 800, and 1500mW on various planes)
I recommend this receiver to go with them. I use an older Racewood type they used to sell, but these are supposed to be at least as good with the same Comtech tuners in them. Apparently Racewood is no longer in business, so here's what replaced them:
I use this 8dbi Patch Antenna, it has been my go-to antenna for a long time now, for years! lol I've been out more then 10 miles using one of these and the 800mW vtx listed above:
On the transmitter side, the stock dipoles that come with them work pretty good together with that patch, but if you want slightly better performance and less weight/drag, consider these: