☁️️ ☁️️ Mini Talon FPV ☁️️ ☁️️

As I mentioned on some of my past videos (and comments) I've had an issue since I built the Mini Talon with noise in the video and audio for the FPV feed. Not so much motor noise, just noisy video and terrible clipping and buzzing in the audio. I tried a couple of different video transmitters (one 400mW, one 800mW) and while one was a little better, the problem was still there. I had another transmitter that I've used in the past on various planes, that I KNOW works well, it's always given me clean video and audio. It's a 300mW Racewood transmitter from DPCAV. I put that one on here, and the video and audio are both much better than with the others. Today I flew it, and wanted to see if dropping to 300mW would limit my range enough to notice... Needless to say it's fine. ;) Enjoy! (I will post ground footage later, next time I fly.)
Recorded with the new RunCam Split
__
Patreon:
You can help to support my channel by using the affiliate links below when making a purchase:
Banggood -
eBay -
Amazon -
Foxeer -
You can also make a donation if you wish to do so at the following link:
Support my channel and my efforts to bring you better content, every little bit helps!
Here's some affiliate links to the video gear I use from Ready Made R/C:
1.3GHz video transmitters (I use 200, 400, 800, and 1500mW on various planes)
I recommend this receiver to go with them. I use an older Racewood type they used to sell, but these are supposed to be at least as good with the same Comtech tuners in them. Apparently Racewood is no longer in business, so here's what replaced them:
I use this 8dbi Patch Antenna, it has been my go-to antenna for a long time now, for years! lol I've been out more then 10 miles using one of these and the 800mW vtx listed above:
On the transmitter side, the stock dipoles that come with them work pretty good together with that patch, but if you want slightly better performance and less weight/drag, consider these: